Page 1: Table Of Contents
Pool Maintenance and Chemical Definitions 21 Intex Pools Operating Time Table Trouble Shooting Guide 22-24 Non Intex Pools Salt Table General Aquatic Safety Non Intex Pools Operating Time Table Limited Warranty Operating Instructions 13-15 Intex Service Center Locations IMPORTANT SAFETY RULE READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING AND USING THIS PRODUCT.
Page 2: Warning
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 IMPORTANT SAFETY RULE Read, Understand and Follow All Instructions Carefully Before Installing and Using this Product. This Saltwater System/Filter Pump is intended to be used only for the purposes described in this manual.
Page 3: Parts Reference
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 PARTS REFERENCE Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts. 5F12 5F13 6F16 6F14 6F15 5NF32 59905 POWER CORD 05F-37 WATER FROM...
Page 4 (104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 PARTS REFERENCE (CONT.) LINER 5F04 5F03 06NF-02 5F01 06NF-05 06NF-30 5F11 05CG-12 REF. NO. DESCRIPTION QTY. REMARK 5F01 Strainer Grid 06NF-02 Threaded Strainer Connector 5F03 Flat Strainer Rubber Washer 5F04 Strainer Nut 06NF-05...
Page 5: Product Information And Specifications
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Product Information and Specifications How the Chlorine is Generated Common salt (sodium chloride) is made up of two elements, sodium and chloride. During the installation of your Saltwater System/Filter Pump, a measured quantity of salt is dissolved in the pool water to make it slightly salty.
Page 6: Set Up Instructions
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Set Up Instructions IMPORTANT: The Saltwater System/Filter Pump must be installed as the last piece of pool equipment in the water return line to the pool. This location extends the life of the titanium plates. Strainer &...
Page 7 (104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Set Up Instructions (cont.) Strainer & Plunger Valve Set Up (18’ and above AGP) The Saltwater System/Filter Pump assembly includes two (2) strainer-control mechanisms that are to be installed in the pool liner's two (2) pre-cut holes. The strainer grid prevents large objects from jamming and/or damaging the filter pump and the plunger valve assembly prevents water from flowing into the filter pump while the filter cartridge is being placed or cleaned.
Page 8 (104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Set Up Instructions (cont.) Saltwater System/Filter Pump 1. Remove the Saltwater System/Filter Pump and hoses from the packaging. 2. Place the Saltwater System/Filter Pump in a location for hose (5NF19) connections to the plunger valve assemblies.
Page 9: Salt & Pool Water Volumes
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Salt & Pool Water Volumes Use only Sodium Chloride Salts Use only sodium chloride (NaCl) salt that is at least 99.8% pure. It is also acceptable to use water conditioning salt pellets (the compressed forms of evaporated salt), but it will take longer time for them to dissolve.
Page 10: Intex Pools Salt Table
Startup Pool Size and 80% for Easy Set & Oval Pool) (CODE “91”) (Lbs) (Kgs) (Lbs) (Kgs) (Gals) (Liters) INTEX ABOVE GROUND POOLS (AGP’s) 15' x 36" 3282 12422 15' x 42" 3861 14614 15' x 48" 4440 16806 CIRCULAR 16' x 42"...
Page 11: Intex Pools Operating Time Table
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Intex Pools Operating Time Table This table shows the operating time required for normal use of the Saltwater System with AGP’s. Operating Time (hours) Water Capacity at different ambient/air...
Page 12: Non Intex Pools Salt Table
Water Capacity (Liters) x Water Capacity (Gals) x Water Capacity (Liters) x 0.025 0.003 0.0067 0.0008 Non Intex Pools Operating Time Table Operating Time (hours) Water Capacity at different ambient/air temperatures 20 - 28 °C 29 - 36 °C 37 - 42 °C...
Page 13 (104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Operating Instructions This unit is the combination of filter pump and Saltwater System. Filter Pump Operation 1. Make sure the unit switch is "OFF". The switch is located on the control box. 2.
Page 14 (104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Operating Instructions (Cont.) Saltwater System Operation After the salt is dissolved, but before starting the chlorine generation be sure that: The system is connected to a grounding type receptacle protected by a ground-fault circuit •...
Page 15 (104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Operating Instructions (cont.) 7. The green and yellow LED lights on the control panel will disappear when the cycle has ended. The system will go into a “Stand-By Mode” with the LED flashing “93”.
Page 16: Alarm Codes & Led Code Chart
2. Low salt level. • Add salt. See “Salt & Pool Water Volumes”. Level 3. Possible electrolytic cell • Contact Intex Service Center. Replace the cell failure. if needed. • Partially drain the pool and refill with fresh water. 1. High salt level.
Page 17 (104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 LED Code Chart LED Reading Definitions Stand-By Mode (Start-up) Zero Operating Hours Minimum Operating Hour (1 hour remaining) Operating Hours (2 hours remaining) Operating Hours (3 hours remaining) Operating Hours (4 hours remaining) Operating Hours (5 hours remaining) Operating Hours (6 hours remaining) Operating Hours (7 hours remaining)
Page 18: Maintenance
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Maintenance IMPORTANT: Unplug power cord before cleaning and close plunger valves or insert black hat-like plugs in strainer opening to prevent water spillage. Plug in the power cord and open plunger valves or remove plugs when maintenance tasks are completed.
Page 19 (104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Maintenance (cont.) 05CG-06 05CG-08 05CG-14 3. Disconnect the water return (to the pool) hose from the Saltwater System outlet. Disconnect angle joint (05CG-14) from the filter housing and flow sensor conduit (05CG-06). 4.
Page 20: Long Term Storage
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Maintenance (Cont.) Filter Cartridge Cleaning (Or Replacement) It is recommended that the filter cartridge be replaced at least every 2 weeks. 1. Make sure the unit is turned off, and disconnect the power cord from the electrical outlet. 2.
Page 21: Intex 3-Way Test Strips
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 INTEX ® 3-Way Test Strips (packed with the Saltwater System/Filter Pump) 3-Way Test Strips can test the “Free Chlorine”, “pH”, and “Total Alkalinity” levels at the same time. Directions and Use: 1.
Page 22: Trouble Shooting Guide
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5” X 10.5” 09/18/2006 Trouble Shooting Guide CAUSE PROBLEM REMEDY FILTER MOTOR • Not plugged in. • Filter cord must be plugged into a 3 wire FAILS TO • Fuse box needs checking. outlet that is protected by a Class A START •...
Page 23 Check to see if cell cord is loose or not • connected properly. Ensure the cell cord is plugged firmly into the cell housing receptacle. • Contact Intex Service Center for replacement. • Contact Intex Service Center for replacement. SAVE THESE INSTRUCTIONS...
Page 24: General Aquatic Safety
See “Maintenance”. 2. Low salt level. • Add salt. See “Salt & Pool Water Volumes”. 3. Possible electrolytic cell failure. • Contact Intex Service Center. Replace the cell if needed. • Partially drain the pool and refill with fresh CODE 92 1.
Page 25: Limited Warranty
Limited Warranty is invalid. If a manufacturing defect is found within this one (1) year period, please contact the appropriate Intex Service Center listed in this manual. The Service Center will determine the validity of the claim.

This manual is also suitable for:

Krystal clean poolwater 8231

Intex Krystal Clean Poolwater 8221 Owner's Manual

Quick Links

TABLE OF CONTENTS

Related Manuals for Intex Krystal Clean Poolwater 8221

Summary of Contents for Intex Krystal Clean Poolwater 8221

This manual is also suitable for:

Table of Contents