Intex Krystal Clean Poolwater 8221 Owner's Manual page 19

Maintenance (cont.)
3. Disconnect the water return (to the pool) hose from the Saltwater System outlet. Disconnect
angle joint (05CG-14) from the filter housing and flow sensor conduit (05CG-06).
4. Check for debris which has passed through the filter and been trapped on the debris screen
(05CG-08). If debris is on the debris screen, remove the debris screen and use garden hose to
flush the debris off.
5. Look inside the electrolytic cell (05CG-01) inspect for scale formation (light colored crusty or flaky
deposits) on the titanium plates. If no deposits and debris are visible reinstall the debris screen
(05CG-08), cell and hose.
6. If deposits and debris are seen on the titanium plates, use a high pressure garden hose and try to
flush them off. Only flush from the direction of water inlet to avoid damaging the flow sensor. Do
not use any metal tool as this will scratch the coating off the plates. Note that a buildup on the cell
indicates that there is an unusually high calcium level in the pool. If this is not corrected, you have
to frequently check and clean the cell. To avoid this, always keep your pool chemistry at the
recommended levels. See "Pool Maintenance & Chemical Definitions" for reference.
7. If flushing does not remove the deposits on the plate then disconnect the cell from the base by
removing the 2 mounting screws (05CG-03). Disconnect the flow sensor from the top of the cell
and unplug the electrolytic cell cord. Soak the cell in a vinegar solution (condiment) for 2-3 hours
and then flush with high pressure water from the garden hose.
8. Reconnect electrolytic cell reversing steps 3, 4, 5 and 7. (Reset the Saltwater System's operating
hours)
NOTE: After cleaning the operating hours have to be reset.
SAVE THESE INSTRUCTIONS
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5" X 10.5" 09/18/2006
05CG-06 05CG-08 05CG-14
Page 19
Titanium Plates
104