Led Code Chart - Intex PureSpa PS-BH-10 Owner's Manual

LED Reading
E80 Water control valve broken
E90
E94 Water temperature too low
E95 Water temperature too high
E96
E99 Water temperature sensor broken • Contact Intex Service Center.
After 72 hours of continuous
heating operation, the pump will
END hibernate automatically. The rapid
heating and water filtration
functions are disabled.
S AVE THESE INSTRUCTIONS
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5" X 10.3" PANTONE 295U 01/26/2016

LED CODE CHART

CAUSE
• Contact Intex Service Center.
• Turn off and unplug the control unit.
• Ensure the outlet cover grid is clean and free
from obstructions.
• Ensure the in/outlet connections on the spa tub
and filter pump are not blocked.
No water flow
• Keep the spa water properly sanitized.
• Be sure the filter cartridge is clean and not
clogged.
• If problem persists, contact Intex Service
Center.
• If the ambient temperature is below 39°F (4°C),
we recommend you do not use the spa.
• Turn off and unplug the control unit, add some
warm water to raise the spa water temperature
above 41°F (5°C), then press the
heat up the water to the desired temperature.
• Press the temperature increase button to set
the desired water temperature.
• If problem persists, contact Intex Service
center.
• Turn off and unplug the control unit. When the
water has cooled down, plug the GFCI/RCD
and restart all over again.
• Turn the heater off, then press the filter and
bubble buttons to lower the water temperature.
• If problem persists, contact Intex Service
Center.
• Turn off and unplug the control unit, use the
cap to stop the water from flowing out of the
tub, disassemble and drain out the control unit.
System Error Reassemble the control unit back to the tub.
Plug the GFCI/RCD and restart all over again.
• If problem persists, contact Intex Service
Center.
• Press the
filter pump.
English
SOLUTION
button to
104
F
o
104
F
o
button to re-active the
Page 15
292
PO