Trouble Shooting Guide (cont.)
PROBLEM
AIR LOCK
• Pump housing and inlet hose
air trapped.
• Inlet and outlet hoses connection
reversed.
INSUFFICIENT
• Insufficient operating hours of the • Increase the Saltwater System
CHLORINE
Saltwater System.
• Insufficient (Less than 2000ppm)
salt level in pool water.
• Chlorine loss due to intense
sunlight exposure.
• The bather load has increased.
• Clogged or dirty electrolytic cell.
WHITE FLAKES
• Excessive calcium hardness is
IN THE WATER
present in pool water.
Power Saving Mode.
NO LED
•
No Salt.
DISPLAY
•
No power supply.
•
Electrolytic cell cord is loose.
•
Power fuse blown.
•
LED failure.
•
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5" X 10.5" 09/18/2006
CAUSE
SAVE THESE INSTRUCTIONS
• Open air release valves, lift and lower the
inlet hose until water starts to flow out of
the air release valves, close air release
valves.
• Lower position of pool outlet connect to
filter pump water inlet, upper position of
pool inlet connect to filter pump water
outlet.
operating time per day. See "Operating
Instructions".
• Test the Salt Level with Test Kit, and adjust
as needed. See "Salt & Pool Water
Volumes".
• Use Pool Cover when the pool is not use
and/or when the unit is operating.
• Increase the Saltwater System
operating time per day. See "Operating
Instructions".
• Remove the cell for inspection, clean it
if necessary. See "Maintenance".
• Drain about 20 to 25% of the pool water
and add fresh water to decrease the
calcium hardness. Visually inspect the
electrolytic cell for scale build-up and clean
the electrolytic cell if necessary.
Press any button (
•
last LED code.
Add salt. See "Salt & Pool Water
•
Volumes".
Check for power cord loose or not
•
connected properly.
Check to see if cell cord is loose or not
•
connected properly. Ensure the cell cord is
plugged firmly into the cell housing
receptacle.
•
Contact Intex Service Center for
replacement.
•
Contact Intex Service Center for
replacement.
Page 23
REMEDY
or
) to view the
104