Intex Krystal Clean Poolwater 8221 Owner's Manual page 17

LED Code Chart
LED Reading
88
00
01
02
03
04
05
06
07
08
09
10
11
12
90
91
92
93
94
"BLANK"
Saltwater System/Filter Pump Stationary Mounting Option
Some countries, especially in the European community, require the product to be secured to the
ground or to a base in a permanent upright position. Check your local authorities to determine if there
is a regulation in your area regarding above-the-ground swimming pool filter-pumps. If yes, then the
product can be mounted to a platform using the two (2) holes located in the base. See drawing below.
The product can be mounted on a cement base or onto a wooden platform to prevent accidental falling
over. Total assembly must exceed 18kg. The European norm EN 60335-2-41 requires this product be
secured to the ground or to a base.
1. The mounting holes are 6.4mm in diameter and spaced 507mm apart.
2. Use two bolts and lock nuts with a maximum of 6.4mm in diameter.
SAVE THESE INSTRUCTIONS
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5" X 10.5" 09/18/2006
Minimum Operating Hour (1 hour remaining)
Operating Hours (2 hours remaining)
Operating Hours (3 hours remaining)
Operating Hours (4 hours remaining)
Operating Hours (5 hours remaining)
Operating Hours (6 hours remaining)
Operating Hours (7 hours remaining)
Operating Hours (8 hours remaining)
Operating Hours (9 hours remaining)
Operating Hours (10 hours remaining)
Operating Hours (11 hours remaining)
Maximum Operating Hours (12 hours remaining)
Alarm Code (Low Water Flow / No Flow)
Alarm Code (Low Salt Level)
Alarm Code (High Salt Level)
Stand-By Mode (Operating Process finished)
Stand-By Mode (no Operating Time input)
No Power or "Power Saving Mode" waiting to start next Saltwater System
cycle, or no salt.
Page 17
Definitions
Stand-By Mode (Start-up)
Zero Operating Hours
104