Intex Krystal Clean Poolwater 8221 Owner's Manual page 13

Operating Instructions
This unit is the combination of filter pump and Saltwater System.
Filter Pump Operation
1. Make sure the unit switch is "OFF". The switch is located on the control box.
2. Connect the power cord to a GFCI protected electrical outlet.
IMPORTANT: To prevent air lock, open the lower plunger valve (connected inlet hose) first
and then the upper plunger valve (connected outlet hose).
3. Grasp a plunger valve handle. Turn the handle counter-clockwise, pull up until it stops, and then
turn it clockwise until the metal protruding notch anchors in the "0/1" position. Repeat for the 2nd
plunger valve. This opens the valves to allow water to flow into the unit.
4. With water flowing into unit, the water pressure will allow the air trapped inside to escape from the
air release valves (5F12 & 05F-37). When all the air has escaped water will flow out of the valves
(5F12 & 05F-37). When this occurs gently finger tighten the valves in a clockwise direction.
5. Turn the switch "ON". The filter pump is now filtering the water.
6. A yellow LED Light on the control panel will light up, that indicates the filter pump is running.
SAVE THESE INSTRUCTIONS
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5" X 10.5" 09/18/2006
Page 13
05F-37
104
5F-12