Safety Rules - Personal Safety - New Holland C227 Service Manual

Safety rules - Personal Safety

Carefully study these precautions, and those included in the external attachment operators
manual, and insist that they be followed by those working with and for you.
1. Thoroughly read and understand this manual and the attachment operators manual before operating this or any
other equipment.
2. Be sure everyone is clear of the machine before starting. Blow the horn, if equipped, three times before starting
engine.
3. Only the operator should be on the machine when in operation. Never allow anyone to climb on to the machine
while it is in motion. If the machine is equipped with an Instructors Seat, this must only be used for training
purposes. Passengers must not be allowed to use the Instructors Seat.
4. Keep all shields in place. Never work around the machine or any of the attachments while wearing loose clothing
that might catch on moving parts.
5. Observe the following precautions whenever lubricating the machine or making adjustments.
Disengage all clutching levers or switches.
•
Lower the attachment, if equipped, to the ground or raise the attachment completely and engage
•
the cylinder safety locks . Completing these actions will prevent the attachment from lowering un-
expectedly.
Engage the parking brake.
•
Shut off the engine and remove the key.
•
6. Always keep the machine in gear while going downhill.
7. The machine should always be equipped with sufficient front or rear axle weight for safe operation.
8. Under some field conditions, more weight may be required at the front or rear axle for adequate stability. This
is especially important when operating in hilly conditions or/when using heavy attachments.
9. Always lower the attachment, shut off the engine, set the parking brake, engage the transmission gears and
remove the key before leaving the operators platform.
10. If the attachment or machine should become obstructed or plugged; set the parking brake, shut off the engine
and remove the key, engage the transmission gears, wait for all machine or attachment motion to come to a
stop, before leaving the operators platform to removing the obstruction or plug.
11. Never disconnect or make any adjustments to the hydraulic system unless the machine and/or the attachment
is lowered to the ground or the safety lock(s) is in the engaged position.
12. Use of the flashing lights is highly recommended when operating on a public road.
13. When transporting on a road or highway, use accessory lights and devices for adequate warning to the operators
of other vehicles. In this regard, check local government regulations. Various safety lights and devices are
available from your NEW HOLLAND CONSTRUCTION dealer.
14. Practice safety 365 days a year.
15. Keep all your equipment in safe operating condition.
16. Keep all guards and safety devices in place.
17. Always set the parking brake, shut off the engine and remove the key, engage the transmission gears, wait for all
machine or attachment motion to come to a stop, before leaving the operators platform to service the machine
and attachment.
18. Remember: A careful operator is the best insurance against an accident.
19. Extreme care should be taken in keeping hands and clothing away from moving parts.
INTRODUCTION
84522361 15/06/2011
5