Basic Connection And Start-Up - Tripp Lite SmartOnline AG-0358 Series Owner's Manual

Operations

Basic Connection and Start-Up

1
Connect your UPS to electrical service
Your UPS must be connected to a dedicated circuit of sufficient
amperage. L6-30 models require a 30A building installation
breaker. For Hardwire models, refer to the Installation section,
UPS Input and Output Overview Table and rating on the UPS
for details.
2
Plug your equipment into the UPS
When input power is applied, the UPS will go into Standby Mode
and the batteries will charge.
Your UPS is designed to support network, server and computer
equipment only.
Note: If the equipment is to be load controlled, make sure to plug
equipment into a load-controlled bank.
3
Turn your UPS on
Press and hold the POWER
as the alarm begins to sound.
4
Select your Language
When your UPS is powered up for the first time, the INPUT AC
LED will light up and the front panel LCD screen will request a
language selection.
Using the UP / DOWN buttons
preference, then press the NEXT
The interface will confirm your selection and provide options to
go back (press BACK ) or to go to the next step
ESC
(press NEXT ).
button for 3 seconds and release
, select your language
button.
1
2
Your model and outlet may differ.
3
Language
English
French
Spanish
Russian
Select
ESC
4
16
Apply
SETUP