Mounting (Tower); Connection And Start-Up - Tripp Lite SUINT3000RTXL2U Owner's Manual

4. Installation

4.2 Mounting (Tower)

The UPS can be mounted in an upright tower position
with optional base stands sold separately by Tripp Lite
(model: 2-9USTAND). When mounting the UPS on
adjustable base stands, make sure the control panel is
toward the top. The control panel may be rotated to
make it easier to read. Remove the 4 front screws
from the front panel and take it off. Pinch the tabs
located on the sides of the LED panel, and rotate it.
Replace the front panel and secure it. Front panel
setup should be performed by service personnel only.
WARNING!
All UPS systems are extremely heavy. Use caution
when lifting and mounting. User must properly
stabilize the UPS when lifting and mounting.

4.3 Connection and Start-Up

Plug the UPS system into an
1
electrical outlet.
The UPS system must be connected to a
dedicated circuit of sufficient amperage. Refer to
the UPS system nameplate for input requirements.
Note: The UPS will pass unfiltered, unregulated power to
the outlets as soon as it is plugged in. Bypass is enabled
from the factory.
After the UPS system is plugged in with a user-
supplied power cord, the following sequence of
events will occur:
1. The fan will turn on and all LEDs will
illuminate momentarily.
2. The percent level LEDs (25%, 50%, 75% and
100%) will illuminate one at a time.
3. The "LINE" and "LOAD" LEDs will
illuminate to indicate normal operation.
Voltage Note: The UPS system supports a nominal AC
voltage setting of 200V, 208V, 220V, 230V or 240V.
230V is the factory default setting. The full output
capacity of 2500 watts is available when the UPS system
is set at 208V, 220V, 230V or 240V. The output capacity
is reduced to 2160 watts when the UPS is set to 200V.
The nominal voltage setting can be changed with the
optional WEBCARDLX internal accessory card. See the
WEBCARDLX documentation for more information about
changing the nominal voltage setting.
18-09-247-933652.indb 6
1
6
2
1
2/13/2019 3:27:27 PM