Front Panel Button Functions; Home Screen Layout - Tripp Lite SmartOnline AG-0358 Series Owner's Manual

3000
Operations
3000

Front Panel Button Functions

There are 5 front panel buttons that offer UPS control and configuration options. To navigate the various information, configuration and
UPS control screens, use the 5-button front panel interface and follow the on-screen prompts and selection options.
Power On / Off Button: This control offers three main functions: Power-On, Power-Off and Clear UPS Fault.
To turn the UPS ON into a protected operating mode, press and hold this button for 3 seconds as the UPS is connected to
input AC power. Release the button when the alarm begins to sound and the UPS will startup into the last configured power
strategy.
To "cold start" the UPS ON into battery mode during power failure conditions, press and hold this button for 3 seconds.
3000
Release the button when the alarm begins to sound and the UPS will startup in battery mode.
3000
To turn the UPS OFF as it's running in battery or protected mode, press and hold this button for 3 seconds. Release the button
when the alarm begins to sound. The UPS will turn off AC output. Once AC output is off, disconnect input power to the UPS and
the UPS will power off completely. 3000
To CLEAR UPS FAULT, press and hold this button as directed on-screen for 3 seconds. The UPS will clear the fault conditions
210 3000
and return to standby or bypass mode.
3000
ENTER Button: This control is used to make selections, confirm options and move forward to the next selection as the UPS is
configured in setup mode. Press this button as directed on-screen in Setup mode to Enter, Confirm or Move Forward in the
3000
configuration process.
UP / DOWN Buttons: These controls offer two main functions: "Up" and "Down" directional control, plus enter / exit setup
mode (when pressed simultaneously). These buttons are used to navigate setup-mode menu options and scroll up or down to
210
view screen contents as necessary.
To ENTER or EXIT UPS SETUP MODE, press these two buttons simultaneously for 3 seconds. Release the buttons when the
alarm begins to sound. The UPS will automatically enter setup mode if both buttons are pressed during LCD display modes.
The UPS will automatically exit setup mode if both buttons are pressed as the UPS runs in UPS setup mode.
ESCAPE Button: This control offers three main functions: Alarm Cancel, Clear Fault and Back / Cancel operations.
To CANCEL UPS ALARM, press this button. If a new alarm condition occurs, the alarm will sound again.
To CANCEL or GO BACK ONE LEVEL, press this button as directed on-screen in Navigation and Setup modes.

Home Screen Layout

The UPS front panel LCD screen is set up to provide continuous UPS operating information using NORMAL MODE and BATTERY MODE
home-screens that continuously report operating mode, protection status, power strategy and a number of battery and load-level operating
parameters.
Operating Mode
Battery Charge %
Battery Charge
"Bars"
Battery Voltage
Power Strategy
3000
3000
Normal Mode Home Screens
Online
<Battery> <Load>
3000
210 3000
Max Efficiency
SETUP
ESC
Load Protected
<Battery>
210
Enabled
SETUP
ESC
15
Protection Status
<Load>
Output Load %
Output Load
3000
3000
Output Load
Output Load
"Bars"
Power Strategy
(Continued)