VINCENT SA-T7 MK Instructions For Use Manual page 34

CONNECTION OF A RECORDING DEVICE
If you want, you can use the RCA sockets "OUTPUT REC" (12) on the back of the appliance to connect
an analogue stereo recording device (e.g. CD recorder, cassette recorder etc.) or another appliance
that is intended for receiving the unchanged, fixed stereo output level (line level) from the signal source
selected on the amplifier at any given time. The output level is independent from the volume setting.
Please note that while the preamplifier is muted (10) the recording output is switched off.
RCA connection
SA-T7MK
Recording device,
e.g. tape recorder
LINE IN
Connect this signal output to the signal input ("LINE IN", "TAPE IN" or "REC IN") on the recording appli-
ance using RCA cables. Please note that some recording equipment can have a slightly detrimental effect
on the audio signal quality. Some recording devices have rather low input impedance, which can slightly
alter the input signal voltage. For maximal music enjoyment we recommend that you connect to the
"REC" terminal only for as long as the recording is actually being made.
CONNECTION OF ONE OR MORE POWER AMPLIFIERS
This preamplifier has two stereo preamplifier outputs with RCA connectors for the main amplifier channels.
In this way it is possible to drive four loudspeakers or bi-amp one pair of loudspeakers (e. g. using two
stereo main amplifiers). The main amplifiers supply the system's loudspeakers and the loudspeakers are
connected to the outputs of these. Instead of each stereo main amplifier shown here you can alternatively
use two mono main amplifiers.
To connect one pair of loudspeakers you will need two main amplifier channels, for example one stereo
main amplifier. Connect both sockets named "1" in the field "OUTPUT" (15) with the RCA input sockets
of the main amplifier channels (often marked as "INPUT" or "POWER AMP IN"). Please pay attention not
to interchange right with left channels. The letters "R" and "L" indicate the correct correlation. You may
further use the SA-T7MK preamplifier output marked with "2" for a headphone amplifier.
You can as well use both stereo outputs at the same time, giving way for up to 4 main amplifier channels
to supply their loudspeaker. For that all you need to do is connect all remaining stereo outputs (15) with
additional main amplifier channel inputs.
34