Icom IC-7200 Instruction Manual page 36

6
SET MODE
■
Set mode (Continued)
Modulation input (Data ON)
Selects the desired connector(s) for modulation input when SSB data/AM data mode is in use.
M (MIC) : Use the signals from [MIC].
A (ACC) : Use the signals from [ACC] (pin11).
M A (MIC/ACC) : Use the signals from [MIC] and [ACC] (pin11).
U (USB) : Use the signals from [USB].
USB Level
Sets the input modulation level of the USB jack to between 0% to 100% in 1% steps.
Speech Level
Adjusts the volume level of the speech function to between 0% and 100%, in 1% steps.
Speech Language
Selects English or Japanese as the language of the speech function.
En : English ; JP : Japanese
Speech Speed
Selects HI (faster) or Lo (slower) as the speech speed.
HI (High) : Faster announcement ; Lo (Low) : Slower announcement
Speech S-level
The received signal level, frequency and mode can be announced by the voice synthesizer. The signal level an-
nouncement can be turned OFF if desired.
When "oF" is selected, the signal level is not announced.
on : The Signal level is announced. ; oF : The signal level is not announced.
Speech [MODE] Key
Selects whether the operating mode is announced with the speech synthesizer when
When "on" is selected, the operating mode is announced when you push
on : The operating mode is announced when pushing
oF : The operating mode is not announced when pushing
Scan Speed
Sets the speed at which channels or frequencies are scanned during scanning.
High and low can be selected.
HI : Fast scan ; Lo : Slow scan
Scan Resume
This item turns the scan resume function ON or OFF.
on : Scan resumes 10 seconds after stopping on a signal (or 2 seconds after a signal disappears).
oF : Scan does not resume after stopping on a signal.
31 31
MODE .
MODE
.
MODE
.
ACC (default)
50% (default)
50% (default)
English (default)
High (default)
ON (default)
OFF (default)
is pushed.
MODE
High (default)
ON (default)