Troubleshooting - Husqvarna V548 Operator's Manual

Refer Lubrication
to
F Replace the oil filter.
Always use good quality grease. Always use
recommended oil, refer to
29 .
To lubricate the front wheels
• Remove the dust cap (A). Grease the nipple (B)
with a grease gun until grease comes out from
the top washer.
A
C
• Lubricate the joint bearing of the front wheels (C)
with a grease gun until grease comes out.
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Engine does not start.
1994 - 002 - 05.12.2022
Technical data on page
B

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
Off) button on page 4 .
Steering controls are not locked in the neutral position.
The battery is too weak. Refer to
18 .
There is dirt in the carburetor or the fuel line.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
Incorrect neutral adjustment. Refer to
tion on page 20 .
Interval
Month
Yearly
ly
X
To lubricate the cutting deck
spindles
1. Set the cutting deck in mow position.
2. Lubricate each cutting deck spindle 2-3 strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
To charge the battery on page
Each Each Each
50 250 500
hours hours hours
X X X
PTO (Power Take-
To adjust the neutral posi-
25