Husqvarna V548 Operator's Manual page 24

Lubrication, general information
• Remove the ignition key to prevent accidental
movements during lubrication.
• Clean the area before you lubricate a part on the
product.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis
or ball bearing grease that prevents corrosion.
Remove unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the
product daily.
Refer Lubrication
to
Lubricate the grease nipple on the pivot axle with a
A
grease gun.
Lubricate the grease nipple on the wheel axle with a
B
grease gun.
Replace the filter.
C Replace the hydraulic oil.
Do a check of the hydraulic oil level.
D Lubricate the grease nipple with a grease gun.
Replace the engine oil.
E
Do a check of the engine oil level.
10
For Parker HT-1000, replace each 750 h. For other qualified hydraulic oils, first change 750 h, then
each 500 h. For other hydraulic oils not listed, first change 750 h, then each 250 h.
11
Replace engine oil each 50 hours when operating with a heavy load or at high ambient temperatures.
24
B
C
D
E
10
11
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean
with alcohol. If the friction between the drive belt
and the pulley is not sufficient after you clean
with alcohol, replace the drive belt.
CAUTION:
other petroleum products to clean drive
belts.
Lubrication schedule
A
Interval
Month
Yearly
ly
X
X
Do not use gasoline or
B
C
A D
F
Each Each Each
50 250 500
hours hours hours
X X
X X
X
X
X X
X X
1994 - 002 - 05.12.2022
X
X
X
X
X
X