Husqvarna V548 Operator's Manual page 21

a) Tighten the neutral bolt to the correct
position, 1 turn at a time. Try to start the
product between each turn. The neutral bolt
is in the correct position when the product
tries to start.
Note:
It is not necessary to keep the
product on if it fully starts when you do this
procedure.
b) Tighten the neutral bolt ½ a turn to 1 turn
more.
c) Tighten the jam nut.
CAUTION:
become bent if you tighten the
jam nut too much. Do not tighten
the jam nut too much.
6. Do the steps that follow on the left side of the
product.
a) Loosen the neutral bolt until it does not touch
the plunger on the neutral switch.
b) Tighten the neutral bolt to the correct
position, 1 turn at a time. Try to start the
product between each turn. The neutral bolt
is in the correct position when the product
tries to start.
Note:
It is not necessary to keep the
product on if it fully starts when you do this
procedure.
c) Tighten the neutral bolt ½ a turn to 1 turn
more.
d) Tighten the jam nut.
CAUTION:
become bent if you tighten the
jam nut too much. Do not tighten
the jam nut too much.
To examine the blades
CAUTION:
balanced blades can cause damage to
the product. Replace damaged blades.
Let an approved service agent help you
sharpen and balance blunt blades.
• Look at the blades to see if they are damaged
and if it is necessary to sharpen them.
To replace the blades
1. Remove the blade bolt.
2. Assemble the new blade with the side without
stamps in the direction of the cutting deck.
WARNING:
can cause objects to eject from
1994 - 002 - 05.12.2022
The bracket can
The bracket can
Damaged or incorrectly
Incorrect blade type
the cutting deck and cause serious
injury. Use only approved blades.
3. Attach the blade bolt. Torque the bolt to 45–50
Nm.
To remove the deck drive belt
1. Park the product on level ground and engage the
parking brake.
2. Lower the cutting deck into the lowest mow
position.
3. Move the belt tensioner to the left side of the
frame to release the belt tension.
4. Remove the deck drive belt from around the
clutch pulley and the stacked pulley in the front
of the cutting deck.
To install the deck drive belt
1. Install the deck drive belt around the clutch pulley
and the stacked pulley in the front of the cutting
deck.
2. Tighten the eye bolt for belt tension of 40–50 lb /
18.2–22.6 kg.
3. Move the belt tensioner to the right side of the
frame to increase the belt tension.
To remove the deck belt
Park the product on level ground and engage the
parking brake before you do this task.
1. Remove the deck drive belt. Refer to
the deck drive belt on page 21 .
2. Remove the 2 belt covers.
3. Remove dirt and unwanted materials from
around the cutter housings and the cutting deck
surface.
To remove
21