Husqvarna V548 Operator's Manual page 12

To engage and disengage the
parking brake
• Pull the parking brake lever rearward to engage
the parking brake. Refer to
page 3 for the location of the parking brake.
Note:
The product must be stationary when
you engage the parking brake.
• Push the parking brake forward to disengage the
parking brake.
To disengage and engage the drive
system
CAUTION:
drive system when the product is parked
on level ground.
If it is necessary to move the product by hand, with
the engine off, the drive system must be disengaged.
• Pull out the drive system lever fully to disengage
the drive system. The drive system lever is on
the left side of the product.
• Push in the drive system lever fully to engage the
drive system.
To set the cutting deck in transport
position or mow position
The cutting deck must be in transport position during
transportation.
• Pull back the deck lifting lever (A) fully. The
transport latch lever (B) locks the deck lifting
lever in transport position.
B
12
Product overview on
Only disengage the
A
• Push the transport latch lever (B) forward to
lower the cutting deck into mow position.
To set the cutting height
1. Set the cutting deck in transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 12 .
2. Push in the button on the top of the pin and pull
the pin out.
3. Put the pin in the hole for the correct cutting
height.
4. Push the transport latch lever forward to lower
the cutting deck into mow position.
To start the engine
1. Push the PTO button to disengage the drive on
the cutting deck.
2. Move the throttle lever to ½ throttle position.
3. Engage the parking brake. Refer to
disengage and engage the drive system on page
12 .
4. If the engine is cold, pull up the choke control
fully.
To
1994 - 002 - 05.12.2022