Grandstream Networks GRP261 Series Administration Manual page 55

Show Target Softkey
Idle Screen Settings
Use Long Label
Call Screen Settings
Transfer Mode via Programmable
Keys
Enable Transfer via Non-Transfer
Programmable Keys
Show Keys Label
EXT Settings
One Page Display Mode
Sync Backlight with LCD
System Settings Page Definitions
Date and Time
NTP Defines the URL or IP address of the NTP server. The phone may obtain the date and time from the server. The
Server default setting is "pool.ntp.org".
Second
Defines the URL or IP address of the NTP server. The phone may obtain the date and time from the server. Allow
ary NTP
user to configure 2 NTP server domain names. GRP will loop through all the IP addresses resolved from them.
Server
NTP
Time interval for updating time from the NTP server. Valid time value is in between 5 to 1440 minutes.
Update
The default setting is "1440" minutes.
Interval
Allow
DHCP
Option
Defines whether DHCP Option 42 should override NTP server or not. When enabled, DHCP Option 42 will override
42
the NTP server if it is set up on the LAN. The default setting is "No".
Overrid
e NTP
Server
Configures whether to show Target softkey on LCD screen.
Enabled by Default
If enabled, the VPK label will extend as desired.
Configures the transfer mode to use when pressing the "Transfer" MPK. Choose
from Blind Transfer, Attended Transfer, or New Call.
Set to Blind Transfer by Default.
Configures MPK with type BLF, Speed dial, etc.,to perform as transfer MPK under
active call.
Disabled by Default.
When labels are hidden, the keys will have reduced size and show icons only.
Toggle: This option will add a softkey used to show or hide labels.
Set to Show by Default.
If enabled, each extension board only shows 20 extensions and EXT 1 to EXT 80
could be displayed on 4 connected boards.
Disabled by Default
If enabled", the extension board backlight will turn off when the LCD becomes idle.
Disabled by Default.
Table 14: Maintenance Page Definitions
Settings → Time and Language