Accessories; Firebox Panel Kits - Jøtul GF 160 DV Installation And Operation Instruction Manual

11. Accessories

Skamol Panel Contents:
• Rear Panel .................. 226029
• Side Panels, 2 ..............226030
Reflective Black Glass Contents:
• Rear Panel ...................226073
• Left Side Panel .............226075
• Right Side Panel.......... 226074
• Cotton Gloves, 2
INSTALL FUEL OR HIGH ALTITUDE
CONVERSION KITS BEFORE INSTALLING
PANEL KITS.
THE PANELS ARE FRAGILE.
SUPPORT EACH WITH BOTH HANDS.
HANDLE THE GLASS PANELS WITH THE COTTON
GLOVES PROVIDED TO MINIMIZE FINGERPRINTS.
SKIN OILS ARE DIFFICULT TO REMOVE FROM THE
GLASS SURFACE.
Pilot Assembly Shield
Figure 11.1. Install Rear Panel.
Tools:
• Flat head screw driver
This procedure applies to both kits.
ORIENT GLASS PANELS WITH THE
SMOOTH SIDE FACING OUT.
1. Set the Rear Panel, bottom first, behind the pilot assembly
shield and resting on the rear shelf. When installed, the two
side panels will hold the rear in place.
2. The side panels rest on the shelves at each side of the burner.
Each panel is secured by a single Retainer Tab located within
the upper corner of the firebox ceiling. Set a panel in place
against the firebox wall and use a flat head screwdriver to pry
the retainer tab down just enough to hold the panel snug in
place.
3. Repeat with the other side panel.
Figure 11.2. Install Side panels.
130112_Rev 2 GF 160 DV 2/22
Retainer Tab
19