9. At this time, make sure all gas, exhaust and electrical connections are complete. Plug
dryer in, and check operation by using the checklist below.
10. (GAS MODELS ONLY) - The burner may not ignite initially due to air in the gas line.
Allowing the dryer to operate on a heat setting will purge the line. If the gas does not ignite
within five minutes, turn the dryer off and wait 5 minu_es. Be sure the gas supply to the
dryer has been turned on. In order to conKrm gas ignition, check the exhaust for heat.
FINAL
INSTALLATION
CHECK
LIST
- Dryer is plugged into electrical outlet and is properly grounded.
- Exhaust ductwork is hooked up and joints taped.
- Plastic flexible duct is NOT used.
- Use only rigid or stiff walled flexible metal vent material.
- Dryer is level with all legs firmly on the floor, with the lock nuts tightened.
- Vinyl feet have been installed.
- Gas Models - Gas is turned on, there are no gas leaks.
- Dryer runs.
- Dryer heats.
- Dryer shuts off.
- Demonstrate use to customer.
PARTS AND LITERATURE
ARE PACKAGED INSIDE
OF DRYER DRUM