Maytag MDE2600AYW Installation Instructions Manual page 18

Connect the neutral (white) conductor of the cord to the center (silver colored) post of the
te_i,iinal block. Connect the grounding (green) wire of the cord to the terminal block support
using the ground strap screw.
Connect the red and black wires of the cord to the outer posts of the terminal block.
Be sure the terminal block nuts are on tight. Secure the power cord in position. Tighten the
strain relief screw(s) in order to.clamp the strain relief to the cord.
Replace the terminal block cover.
WARNING: If converting from 4-wire electrical systems to 3-wire, the ground strap must
be reconnected to terminal block support to ground the dryer flame to the neutral conductor
A
Terminal 8lock
Cover Plate
B
(_ 3-Wire System
o
Neutral Ground
Post _-. Strap
,/
Terminal
Block
Ground
Strap
Screw
Terminal
Block _-_
_uppor_
Hole for
o _
power cord
and
strain relief
!