Table of Contents
Related Manuals for Neilsen CT2283
Summary of Contents for Neilsen CT2283
- Page 1 1/2” DR AIR RATCHET CT2283 ORIGINAL INSTRUCTIONS Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.
-
Page 3: Ec Declaration Of Conformity
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: 1/2” DR AIR RATCHET Model: CT2283 Applicable EC Directives: EC Machinery Directive 2006/42/EC Harmonized standards EN ISO 11148-6:2012 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. -
Page 4: Specification
1.SPECIFICATION Model；CT2283 Max. air pressure: 6.2 bar (90 psi) No load speed: 180/min Air consumption: 5.4cfm Max. torque: 75 ft-lb Air inlet: 1/4" 2. SAFETY INSTRUCTIONS • Follow all workshop safety rules, regulations, and conditions when using wrench. • Do not wear watches, rings, bracelets or loose clothing when using air tools. -
Page 5: Technical Description
3. TECHNICAL DESCRIPTION Ratchet anvil 1/2” Trigger Reverse bottom Air inlet... -
Page 6: Air Supply
4. AIR SUPPLY 1. Ensure tool air valve (or trigger) is in “off ” position before connecting to the air supply. 2. You will require an air pressure of 90psi, and an air flow according to specification. WARNING! Ensure the air supply is clean and does not exceed 90psi while operating the tool. -
Page 7: Operation
5. OPERATION WARNING: Ensure you read, understand and apply safety instructions before use. General operation instructions • Attach an air hose (not included) to the compressor’s air outlet. Connect the air hose to the air inlet of the ratchet wrench. •... -
Page 8: Maintenance
6. MAINTENANCE WARNING: Disconnect wrench from air supply before changing accessories, servicing or performing maintenance. Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous. Lubricate the air wrench daily with a few drops of air tool oil dripped into the air inlet DO NOT use worn or damaged sockets. - Page 9 8. SYMBOLS In this manual and/or on the machine the following symbols are used: Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance of the instructions in this manual. Wear hearing protection. Wear safety goggles.
-
Page 10: Exploded View
9. EXPLODED VIEW... - Page 12 CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K. Made in China...