Kia Telluride 2023 Manual page 370

Driver assistance system
Always pay attention to road and driv-
ing conditions while driving.
僅 When you are towing a trailer or
another vehicle, turn off Navigation-
based Smart Cruise Control for safety
reasons.
僅 After you pass through a tollgate on a
highway (or motorway), Navigation-
based Smart Cruise Control will oper-
ate based on the first lane. If you enter
one of the other lanes, Navigation-
based Smart Cruise Control might not
operate properly.
僅 The vehicle will accelerate if the driver
depresses the accelerator pedal while
Navigation-based Smart Cruise Con-
trol is operating, and the function will
not decelerate the vehicle. However, if
the accelerator pedal is depressed
insufficiently, the vehicle may deceler-
ate.
僅 If the driver accelerates and releases
the accelerator pedal while Naviga-
tion-based Smart Cruise Control is
operating, the vehicle may not decel-
erate sufficiently or may rapidly
decelerate to a safe speed.
僅 If the curve is too large or too small,
Navigation-based Smart Cruise Con-
trol may not operate.
NOTICE
僅 A time gap could occur between the
navigation's guidance and when Navi-
gation-based Smart Cruise Control
operation starts and ends.
僅 The speed information on the cluster
and navigation may differ.
僅 Even if you are driving at a speed
lower than Smart Cruise Control set
speed, acceleration may be limited by
the curve sections ahead.
6 74
Navigation-based Smart Cruise Control (NSCC)
僅 If Navigation-based Smart Cruise
Control is operating while leaving the
main road to enter an interchange,
junction, rest area, etc., the function
may operate for a certain period of
time.
僅 Deceleration by Navigation-based
Smart Cruise Control may feel it is not
sufficient due to road conditions such
as uneven road surfaces, narrow
lanes, etc.
This device complies with Indus-
try Canada licence-exempt RSS
standard(s).
Operation is subject to the following
conditions:
1. This device may not cause interfer-
ence, and
2. This device must accept any interfer-
ence, including interference that may
cause undesired operation of the
device.
3. Changes or modifications not
expressly approved by the party
responsible for compliance could void
the user's authority to operate the
device.