Exmark COMMERCIAL 30 Setup Instructions

Loose Parts
Use the chart below to verify that all parts have been shipped. Part numbers not shown are available on the dealer
extranet.
Dealer Pack
Part #
—
Literature Pack
Manual, Operator's
Manual, Engine Operator's
Removing the Unit from the Box
Remove the unit from the box.
Installing the Handle
1. Remove the handle mounting screws from LH and
RH sides of the mower (reference Figure 1).
1. Handle bracket
2. Handle mounting screw
2. Unfold the handle to the operating position.
© 2012—Exmark Mfg. Co., Inc.
P.O. Box 808
Beatrice, NE 68310
Description
Warranty Registration Reminder
Figure 1
3. Wire tie
4. Handle
COMMERCIAL 30
For Serial Nos. 313,000,000 & Higher
Qty.
Fill out the online warranty registration
form.
3. Reinstall the handle mounting screws on both sides
to secure the handle to the mower housing (see
Figure 1). Tighten all hardware on the handle.
4. Use the wire tie to secure the cables to the lower part
of the handle as shown in Figure 1. Tighten all wire
ties on the handle.
5. Trim the wire ties.
Note: The height of the handle can be adjusted for
comfortable operation. Stand behind the handle to
determine the height. To adjust the handle height,
position the hardware into one of the three holes located
at the bottom of the handle bracket.
Service the Engine
Important: The mower does not come with oil in
the engine.
Filling the crankcase with oil
Initially, fill the crankcase with 30 ounces (0.88 liters)
of oil. Exmark 4-Cycle Premium Engine Oil is
recommended. Refer to the Engine Owner's Manual for
an acceptable alternative. Do Not overfill.
Oil Capacity
With Oil Filter
All Rights Reserved *4500-917* A
Part No. 4500-917 Rev. A
Printed in the USA
Setup Instructions
Use
30 ounces (0.88 L)