Internet Connection; Creating A Bluetooth Connection With A Mobile Phone - Magellan MobileMapper MobileMapper 6 Getting Started Manual

Internet Connection

Creating a
Bluetooth
Connection with a
Mobile Phone
You can access the Internet from your MobileMapper 6 if you
have a mobile phone available with Bluetooth and GPRS
capabilities. To perform the connection to the Internet, you
need to use the following three items:
• Bluetooth for a wireless connection to the mobile phone.
NOTICE: Bluetooth will sometimes need to be turned back
on after the receiver has been suspended.
• Modem connection for a GPRS connection to your access
provider.
• Internet Explorer to access the desired site and view its
web pages.
• Turn on your mobile phone and make sure its Bluetooth is
enabled and visible. If necessary, refer to the phone
manufacturer's documentation for more information on
how to operate Bluetooth in this phone.
• Keep the mobile phone at a distance less than 10 meters
from MobileMapper 6.
• Turn on MobileMapper 6.
• On MobileMapper 6, tap Start, then Settings.
• Tap on the Connections tab.
• Tap on the Bluetooth icon.
• Tap on the Add New Device... line in the list box. Bluetooth
then starts searching.
After the search sequence, the names of the detected
units are listed on the screen. Your mobile phone should
normally be part of the list.
• Tap on the name of your mobile phone and then tap Next
(bottom right).
• Using the virtual keyboard, enter a passcode of your
choice (a two-digit figure for example). This step is for
pairing and securing the connection with the mobile
phone.
• Tap Next. Wait until the spinning hourglass disappears.
• Whatever the model used, your mobile phone should now
respond by asking you to confirm the Bluetooth
connection to MobileMapper 6 and enter the same
passcode. In the meantime, a spinning hourglass is shown
on the MobileMapper 6 screen.
15