Attaching The Magellan Roadmate Receiver To The Car Cradle; Adjusting The Mount For Optimum Viewing; Connecting Power; Checking Connection And Final Adjustments - Magellan RoadMate 3030 User Handbook Manual

Hide thumbs Also See for RoadMate 3030:

Table of Contents

Attaching the Magellan RoadMate receiver to the Car Cradle

Slide the Magellan RoadMate receiver on the car cradle so that the slot on the

Magellan RoadMate receiver aligns with the tab on the car cradle. Slide the

Magellan RoadMate receiver all the way down until it rests on the 'feet'. You should

notice a click when the receiver is fully mounted in the cradle.

Loosen the adjustment locking knob and position the Magellan RoadMate receiver

for optimum viewing. Once set, tighten the locking knobs. (Never attempt to adjust

the mount while driving.)

Plug the end of the vehicle power adapter into a 12VDC vehicle power receptacle. Be sure to avoid routing the

power cable over airbags.

Note: Some vehicles apply power to the vehicle power receptacle only when the ignition is on.

If the power indicator light on the vehicle power adaptor is on, power is being supplied to the Magellan RoadMate

receiver. If it is not on, check the cable connection to the vehicle power receptacle. If the light is still not on, turn

the vehicle's ignition on.

Power Switch

The Magellan RoadMate uses a spring-loaded slider switch to power the receiver on and off.

It is recommended that the Magellan RoadMate receiver is not left in plain view while unattended for reasons of

theft.

Please note that the Magellan RoadMate receiver is a receiver only and does not transmit GPS location signals.

Neither the receiver nor the vehicle can be tracked using the Magellan RoadMate receiver.

Spring Switch

•

Slide to the left to turn the

receiver on or off.

•

Slide to the left to turn the

receiver off.

Table of Contents