Securing The Car Cradle; Adjusting The Mount For Optimum Viewing; Connecting Power; Checking Connection And Final Adjustments - Magellan RoadMate N393M Series User Manual

Securing the Car Cradle

Clean the area on the windshield that has been selected for mounting the
Magellan RoadMate receiver. Let the area dry completely.
Make sure that the lever at the base of the adjustable mount is in the up
position. Place the base of the car cradle firmly over the area where it will be
placed. Push the lever at the base of the swivel mount all the way down until it
snaps in place. Carefully let go of the assembly, making sure that it is securely
mounted.
(The Car Cradle shown here may be different from the Car Cradle supplied
with your Magellan RoadMate receiver, but the installation is the same for all
cradle styles.)

Adjusting the Mount for Optimum Viewing

Loosen the adjustment locking knob and position the Magellan RoadMate
receiver for optimum viewing. Once set, tighten the locking knobs. (Never
attempt to adjust the mount while driving.)

Connecting Power

Plug the end of the vehicle power adapter into a 12VDC vehicle power
receptacle. Be sure to avoid routing the power cable over airbags.
Note: Some vehicles apply power to the vehicle power receptacle only when
the ignition is on.

Checking Connection and Final Adjustments

If the power indicator light on the vehicle power adaptor is on, power is being
supplied to the Magellan RoadMate receiver. If it is not on, check the cable
connection to the vehicle power receptacle. If the light is still not on, turn the
vehicle's ignition on.

Power Button

Press the power button to turn the receiver on or off (suspend mode). Suspend
mode allows the receiver to turn on quickly the next time you use it. However,
if you want to turn the receiver completely off, press the power button and hold
for 3 seconds or more. (Turning the receiver completely off and then back on
[Power Reset] can sometimes solve any problems encountered while using
the receiver.)
12