Stihl SR 200 Instruction Manual page 14

English
In California, it is a violation of § 4442 or
§ 4443 of the Public Resources Code to
use or operate gasoline-powered tools
on forest-covered, brush-covered or
grass-covered land unless the engine's
exhaust system is equipped with a
complying spark arrester that is
maintained in effective working order.
The owner/operator of this product is
responsible for properly maintaining the
spark arrester. Other states or
governmental entities/agencies, such as
the U.S. Forest Service, may have
similar requirements. Contact your local
fire agency or forest service for the laws
or regulations relating to fire protection
requirements.
Tighten all nuts, bolts and screws except
the carburetor adjustment screws after
each use.
For maintenance items please also refer
to the maintenance chart in this
instruction manual.
Store the power tool in a dry and high or
locked location out of reach of children.
Before storing for longer than a few
days, always empty the fuel tank. See
chapter "Storing the machine" in this
instruction manual.
Store fuel in an approved and properly
labeled safety-type canister only. Take
care when handling gasoline! For health
and safety reasons, avoid direct contact
with the skin and avoid inhaling fuel
vapor!
12
Assembling the Unit
NOTICE
The solution hose and throttle cable are
already connected and must not be
kinked while assembling the machine.
The combination wrench and
screwdriver are in the supplied
accessory bag.
Fitting the pleated hose on the elbow
2
1
Open the hose clamp (1) and fit it on
N
the pleated hose (2).
Engage the tab in the recess.
N
3
Push the pleated hose (2) over the
N
slip ring (3) as far as stop.
Line up the hose clamp (1) and slip
N
ring (3):
the two lugs (arrow) on the slip ring
–
face up.
The hose clamp's hook faces
–
outwards.
Tighten down the screw (arrow).
N
Mounting the Control Handle
2
Open up the control handle (1) with
N
liner (2) and push it over the stub (3)
of the pleated hose.
3 1
2
1
3
SR 200