Wireless Antennas - HP Spectre 13x2 Pro Maintenance And Service Manual

Wireless antennas

Description
Antenna Kit (includes WLAN antenna cables and transceivers and WLAN antenna cables and
transceivers)
Before removing the wireless antenna cables and transceivers, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
a. Tablet battery (see
b. Proximity sensor module (see
c. Webcamera/microphone module (see
d. WWAN module (see
e. Volume button board (see
Remove the wireless antenna cables and transceivers:
1. Disconnect the WLAN antenna cables (1) from the WLAN module.
2. Release the wireless antenna cables from the retention clips (2) and routing channel built into the
display assembly.
60 Chapter 5 Removal and replacement preliminary requirements
Back cover on page 36), and then remove the following components:
Tablet battery on page 37)
Proximity sensor module on page
Webcamera/microphone module on page
WWAN module on page 44)
Volume button board on page
Spare part number
736879-001
38)
39)
49)