Preparing For Use; To Inspect The Logic Analysis System; To Apply Power - Agilent Technologies 16900A Service Manual

2

Preparing for Use

To inspect the logic analysis system

WA R N I N G

To apply power

16
1 Inspect the shipping container for damage.
If the shipping container or cushioning material is
damaged, keep them until you have checked the contents
of the shipment and checked the instrument mechanically
and electrically.
Hazardous voltages exist in this instrument. To avoid electrical
shock, do not apply power to a damaged instrument.
Check the supplied accessories.
2
Accessories supplied with the logic analysis system are
listed on page 4.
Inspect the product for physical damage.
3
Check the logic analysis system and the supplied
accessories for obvious physical or mechanical defects. If
you find any defects, contact your nearest Agilent
Technologies Sales Office. Arrangements for repair or
replacement are made, at Agilent Technologies' option,
without waiting for a claim settlement. Contact
information is located on
Connect the supplied power cord to the instrument and
1
to the power source.
This instrument autodetects the line voltage from 115 VAC
to 230 VAC. It is equipped with a three- wire power
cable. When connected to an appropriate AC power
outlet, this cable grounds the instrument cabinet. The
type of power cable plug shipped with the instrument
depends on the model ordered and the country of
destination. The 16900A and 16902A should only be used
with the notched power cord provided due to the high
power requirements of the instruments. Refer to
Cables and Plug Configurations"
information on power cables.
Turn on the power switch located on the front panel.
2
page 4.
on page 100 more
16900A, 16902A, and 16903A Service Guide
"Power