Water Intake Fault - Miele DA 420V-6 Operating Instructions Manual

Water intake fault

Problem
The / indicator
light flashes on and off.
 and  appear
alternately in the time
display.
The dishwasher stops
during a programme.
The / indicator
light is flashing.
The fault number  or
 appears in the
display.
The dishwasher stops
during a programme.
The warning buzzer is
sounding.
Fault number 8
appears in the time
display.
Possible cause and remedy
The tap is turned off.
 Turn on the tap fully.
Before rectifying the problem, you must:
 Switch the dishwasher off with the  button.
Water intake is restricted.
 Turn on the tap fully and start the programme
again.
 Clean the filter in the water inlet (see "Cleaning
and care – Cleaning the water inlet filter").
 The water connection pressure is lower than
50 kPa.
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see "Installation – Drainage").
A technical fault has occurred.
 Switch the dishwasher off.
 Turn off the tap.
 Call Miele.
Problem solving guide
83