Table of Contents
Advertisement
Units of Measure
The AirMap can show its data in many different
formats. For example, distance can be displayed
in statute miles (MI), nautical miles (NM), or kilo-
meters (KM).
The following can be changed on the Units of Mea-
sure menu: (Defaults shown in bold)
Distance .................. miles, nautical miles, kilometers
Speed ...................... miles per hour, knots, kilometers per hour
Bearing .................... magnetic, true
Altitude .................... feet, meters
Clock ....................... 12-hour (a.m.-p.m.), 24 hour
Position Format ....... degrees, minutes, and thousands of a minute
To change a unit of measure, first select the "Units
of Measure" from the "System Setup" menu. The
screen shown at right appears. To change a set-
ting on this menu, highlight the desired selection,
then press the left or right arrow key. You can
change one or all of the settings on this page. When
you're finished, press the EXIT key.
Position Format
The AirMap can show the position in degrees, minutes, and hundredths
of a minute (36° 26.106') or degrees, minutes, and seconds (36° 26' 06.3".
It can also show position in UTM's or Universal Transverse Mercator pro-
jection.
UTM's are marked on USGS topographic charts.
This system divides the Earth into 60 zones hori-
zontally, each approximately 6 degrees wide in lon-
gitude. The Earth is then divided into 20 zones
vertically, which are lettered from "C" to "X". For
example, 15 S means that the position shown to
the right of the "S" is in grid 15 horizontally and "S"
vertically. The numbers to the right of the "S" show
the position in meters from points inside the zone.
To change the position format, highlight the Units of Measure menu, then
degrees, minutes, seconds
UTM
61
Advertisement
Table of Contents
