Panel Removal - Scotsman Prodigy ELITE A Series Installation And User Manual

MC0530 through MC1030
Remote Cooled User Manual

Panel Removal

1. Locate and disengage the two quarter turn
captured screws at the bottom of the front panel.
2. Pull the front panel out at the bottom.
3. Lift the front panel up and off the machine.
4. Remove two screws at the front of the top panel.
Lift up the front of the top panel, push the top
panel back an inch, then lift to remove.
5. Locate and loosen the screws holding each side
panel to the base. Left side panel also has a
screw holding it to the control box.
6. Pull the side panel forward to release it from the
back panel.
This manual covers several models of remote cubers.
The model number on the ice machine can be found
either on the dataplate, which is on the back panel, or
the serial number tag, which is behind the front panel.
See the illustration for the locations of the dataplate
and the serial number tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on the
dataplate on the condenser near the quick connect
fittings.
Write the model and serial numbers here:
Model
Ice machine
Bin
Condenser
Write the day of start up here:_______________
Uncrate and Set Up
Begin with the ice storage bin or dispenser. If a bin,
remove the carton, and, using part of the carton as
a cushion, tip the bin on its back to remove the skid.
Attach the supplied legs or optional casters. Return
the bin to a normal, upright position.
1. Remove
Screws
Check the bin top gasket for rips or gaps. If recycling
an older bin, replace the gasket or repair with food
grade sealant prior to placing the ice machine on the
bin.
Install the bin top adapter or ice dispenser adapter, if
one is required for the application.
If the ice machine has not been unpacked, do so now.
Remove the carton from the skid. Lift the ice machine
Serial Number
off the skid directly onto the bin.
Note: The machine is heavy. Use a mechanical lift if
necessary.
Secure the ice machine to the bin with the hardware
provided (two metal straps and four bolts).
Place the bin and ice machine in the selected location
and level it using the bin leg levelers.
Remove the white plastic covering the panels.
June 2022
Page 7
5
3
2
Dataplate Location and panel Removal
Dataplate
Location
5
4. Remove
Screws