Panel Removal - Scotsman C0522 Installation And User Manual

C0522 through C1030
Remote Condenser Models - User Manual

Panel Removal

1. Locate and loosen the two screws at the front
edge of the top panel.
2. Pull the front panel out at the top and lift it up
and off the base.
3. Remove two screws at the front edge of the
top panel, and lLift up the top panel until it
clears the front of the side panels, then push
back 1" and lift it up and off the machine.
4. Locate and loosen the screws holding each
side panel to the base.
5. Pull the side panel forward to release it from
the back panel.
This manual covers several models of remote
cubers. The model number on the ice machine can
be found either on the dataplate, which is on the
back panel, or the serial number tag, which is
behind the front panel. See the illustration for the
locations of the dataplate and the serial number
tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on
the dataplate on the condenser near the quick
connect fittings.
Write the model and serial numbers here:
Model
Ice machine
Bin
Condenser
Write the day of start up here:_______________
Switch Bezel
All models ship with the On and Off switches front
accessible. if desired, the On and Off switches can
be covered up to prevent unauthorized use by
changing the bezel in the front panel's trim strip. A
cover up bezel is available from the local Scotsman
distributor.
See the label on the front panel for instructions on
changing the bezel.
Uncrate and Set Up
Begin with the ice storage bin or dispenser. If a bin,
remove the carton, and, using part of the carton as
a cushion, tip the bin on its back to remove the
skid. Attach the supplied legs or optional casters.
Return the bin to a normal, upright position.
Check the bin top gasket for rips or gaps. If
recycling an older bin, replace the gasket or repair
with food grade sealant prior to placing the ice
machine on the bin.
Serial Number
Install the bin top adapter or ice dispenser adapter,
if one is required for the application.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Lift the ice
machine off the skid directly onto the bin.
Note: The machine is heavy. Use a mechanical lift
if necessary.
Secure the ice machine to the bin with the
hardware provided (two metal straps and four
bolts).
Place the bin and ice machine in the selected
location and level it using the bin leg levelers.
December 2011
Page 8
5
3
1. Remove
Screws
2
Serial
Plate
2
Dataplate Location and Panel Removal
Dataplate
Location
5
4. Remove
Screws