Furuno ECDIS FMD-3200 Installation Manual page 26

2. WIRING
2.1.2 How to connect cables inside the processor unit
Fabrication
Fabricate JIS cables as shown below to connect them to the WAGO connectors on
the I/O Board 24P0124 inside the processor unit.
For locations of cables and cores, see the sticker on the reverse side of the top cover.
(All dimensions in millimeters)
Fabrication of TTYCS series
Cable tie
(supplied)
Fabrication of TTYCSLA series
Wiring for WAGO connector
Wire
Twist
Procedures
1. Twist the conductor.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is ecure.
2-6
Armor
30
5
Vinyl tape
After exposing cores,
wind shield around the armor.
Clamp here by cable clamp.
Sheath
30
Vinyl tape
Clamp here by cable clamp.
Cable tie
(supplied)
Press downward.
Terminal opener
WAGO connector
Shield
L
6
Cable type (JIS)
TTYCS-4, TTYCSLA-4,
TTYCS-1Q, TTYCSLA-1Q
TTYCS-10, TTYCSLA-10
100
Drain wire
L
5
Pass the vinyl sheath (local supply)
onto the drain wire, then attach the
crimp-on lug (preattached to the
earth clamp on the processor unit) to it.
6
Crimp-on lugs
for drain wires
Processor unit, cover removed
Length of "L"
400
380