Furuno ECDIS FMD-3200 Installation Manual page 24

2. WIRING
Fabricating LAN cable
Fabricate the LAN cable (FR-FTPC-CY, DTI-C5E350 VCV), as shown below. (Wrap
both edges of the armor with vinyl tape.) Confirm that the shield of the cable touches
to the shell of the modular plug.
Note 1: Be sure to use the shielded modular plug that is supplied with the LAN cable.
Note 2: This equipment can use either straight or crossover cables.
Cable jacket Armor
1
Expose inner vinyl sheath.
4
approx. 9 mm
Fold back drain wire and
cut it, leaving 9 mm.
7
Using special crimping tool
MPT5-8AS (PANDUIT CORP.),
crimp the modular plug.
Finally check the plug visually.
1 WHT/GRN
2
3 WHT/ORG
4
5 WHT/BLU
6
7 WHT/BRN
8
2-4
30 55
Inner vinyl sheath
Outer vinyl sheath
2
Remove the inner vinyl sheath
by approx 25 mm. Be careful
not to damage inner shield
and cores.
5
approx. 11 mm
Straighten and flatten the
cores in order and cut them,
leaving 11 mm.
1
[Cross cable]
WHT/ORG 1
GRN
WHT/GRN 3
BLU
WHT/BLU 5
ORG
WHT/BRN 7
BRN
Wrap vinyl tape. (width: 20 mm)
3
25 mm
6
Modular plug
8
1 WHT/ORG
2 ORG
ORG 2
3 WHT/GRN
4 BLU
BLU 4
5 WHT/BLU
6 GRN
GRN 6
7 WHT/BRN
8 BRN
BRN 8
approx. 9 mm
Fold back the shield, wrap it
onto the inner vinyl sheath
and cut it, leaving 9 mm.
Drain wire
Insert the cable into the modular
plug so that the folded part of
the shield enters into the plug
housing. The drain wire should
be located on the tab side of
the jack.
[Straight cable]
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8