Roland Camm-3 PNC-3200 Programmer's Manual page 29

Machine coordinate
origin point
External workpiece origin
point offset amount
Setting the Amount of Offset
This sets the amount of offset used by the cutter compensation (G41 and G42). The format for setting the amount of offset is as follows.
G10P number [R offset ]
The offset number for which an amount of offset is to be specified is indicated by number. An integer from 1 to 10 may be specified.
The amount of offset is indicated by offset. A setting within the range of -10.00 to 10.00 mm (or within the range of -0.39 inch to 0.39
inch for inch input) may be made.
Setting a negative value for the amount of offset causes the direction of offset to be reversed.
Example: When an amount of offset of -3 mm is specified for offset number 1
G00G41H01X100.0
Offset of -3 mm to the left-hand side relative to the direction of forward movement = 3 mm offset to the right-hand side
* Reverse-direction offsets is also applied to G42.
The amount of offset can be specified using the LCD panel on the PNC-3200. (Refer to the "User's Manual 3 Cutting Using NC-Codes"
for a description of the procedure.)
Z
Z
Y
Workpiece
coordinate system 1
X
EXOFS
Z
Y
Workpiece
coordinate system 4
X
Z
Y
Workpiece
coordinate system 2
X
Y
Workpiece
coordinate system 3
X
Z
Y
Z
Workpiece
coordinate system 6
X
Y
Workpiece
coordinate system 5
X
27