Roland Camm-3 PNC-3200 Programmer's Manual page 11

G10 can be used to set not only the amount of shift for all workpiece coordinate systems, but also amounts of offset for each individual
workpiece coordinate system.
Selecting any of the workpiece coordinate systems from G54 to G59 and executing G92 causes the following to occur.
Y
10.0
Because G92 sets the current tool position to a desired coordinate value, the workpiece coordinate system selected at that time comes to
have a new origin point. The distance between the origin coordinate points before and after G92 is specified (that is, the amount of shift
of the coordinate system) is added to each workpiece origin point offset amount. This causes the workpiece coordinate systems from
G54 to G59 to be shifted by the same distance.
Z
Amount of offset
by G92
Workpiece origin
point offset amount
Machine coordinate
origin point
Z
Y
Workpiece
coordinate system 1
Amount of offset
by G10
Workpiece origin
point offset amount
Machine coordinate origin point
Tool
G92X5.0Y5.0
executed at
this position
X
15.0
Z
Workpiece
coordinate system 4
Y
Z
Workpiece
coordinate system 1
X
coordinate system 2
Z
X
Y
Workpiece
coordinate system 1
Y
Y
Tool
5.0
5.0
Amount of
offset by G92
Z
Y
Workpiece
X
coordinate system 3
Z
Y
Workpiece
X
coordinate system 6
X
X
X
Y
X
Y
Z
Workpiece
X
Workpiece
coordinate system 5
Y
X
9