Table of Contents
Advertisement
Error message
Bad Parameter
Address Undefined
Parameter Undefined
Code Cannot Execute
Program Number
Not found
Sub-Program
Nest Over
Display Operations When an Error Occurs During Program Execution
Error display
Bad Parameter
O0001
O0001
G17G41H03G00X10.Y5.
Display of the block containing the error
Error While Registering Cutting Data
A check of subprograms is carried out when a program is saved in the buffer. Depending on the results of the check, one of the follow-
ing error messages may be displayed.
Error message
Sub-Program
Table Over
Duplicate
Sub-Program Number
The value of a parameter exceeds the allowable range, or the value of the radius for circular
interpolation or the amount of offset is not correct.
Only a parameter has been set. The code which specifies the parameter has not been set.
A parameter has not been set.
This is displayed when an attempt was made to execute an unrecognizable command, when
cutter compensation was started while in the circular interpolation mode, or when an attempt
was made to execute a command which cannot be used during tool-diameter compensation.
The program number specified by M98 or M99 could not be found.
An attempt was made to call a fifth-level subprogram from a fourth-level subprogram of a main
program.
Pause display
FEED HOLD
Hit CANCEL to Break
There are more than ten subprograms. The maximum number of subprograms that can be
specified in one set of data is ten.
Stop sending data, and press the [CANCEL] key.
Correct the program and resend the data.
The program contains multiple subprograms with the same program number. The same
program number may not be set for more than one subprogram within a single set of data.
Stop sending data, and press the [CANCEL] key.
Correct the program and resend the data.
Description
Program execution
is stopped
All commands in the block
containing the error are
ignored, and operation is
resumed with the next block
Description
17
Advertisement
Table of Contents
