Lexmark Platinum Pro905 User Manual page 153

Error Message:
Phone Line is connected to
the incorrect jack on the
back of the machine.
Digital line detected
Failed to Connect
Phone Line Error
Phone Line Not Connected
Phone Line Busy
No Answer
No Caller ID
Call Stopped
What it indicates:
The telephone cable is connected to
the wrong port on the back of the
printer.
The printer is connected to a digital
line.
The printer cannot detect a dial tone. See the "Fax troubleshooting
Your telephone line or the telephone
line of the receiving fax machine is
busy. This happens especially if the
printer is sharing the line with other
devices (telephone, answering
machine).
Auto Answer may have been turned
off on the receiving fax machine.
Your printer stopped the call because
the incoming fax has no sender
information. You may have chosen to
block faxes with no Caller ID or faxes
without Caller IDs are not allowed in
your country or region.
Troubleshooting
153
Possible solutions:
Connect the phone cable to the
on the back of the printer.
The printer is an analog device and
must be connected to an analog line.
To connect the printer to a digital line,
you must use a digital line converter or
a filter.
For more information, see the "Setting
up the printer to fax" section.
checklist."
•
Set the printer to redial.
•
Increase the time between the
redial attempts.
•
Place a test call to the number to
which you want to send a fax to
make sure that it is working
correctly.
•
If the telephone line is being used
by another device, then wait until
the other device is finished before
sending the fax.
•
Schedule to resend the fax at a later
time.
•
Set the printer to scan before
dialing. The scanned document is
saved in the printer memory. The
printer can then retrieve it and
automatically redial the number.
•
Verify the number, and then resend
the fax.
•
Set the printer to redial.
Note: Depending on your country
or region, there may be a limit on
the number of redial attempts,
regardless of the redial settings
that you set in your printer.
•
Schedule to resend the fax at a later
time.
Disable Block No-ID.
port