Specifications & Consumer information
Lubricant
Brake fluid
Rear differential oil (4WD)
Transfer case oil (4WD)
Fuel
Recommended SAE viscosity number
Always be sure to clean the area around any filler plug, drain plug, or dipstick before checking or draining
any lubricant. This is especially important in dusty or sandy areas and when the vehicle is used on unpaved
roads. Cleaning the plug and dipstick areas will prevent dirt and grit from entering the engine and other
mechanisms that could be damaged.
Engine oil viscosity (thickness) has an effect on fuel economy and cold weather operating (engine start and engine
oil flowability). Lower viscosity engine oils can provide better fuel economy and cold weather performance, however,
higher viscosity engine oils are required for satisfactory lubrication in hot weather. Using oils of any viscosity other
than those recommended could result in engine damage.
8-8
Volume
As required
0.7 l (0.74 US qt.)
0.65 l (0.69 US qt.)
Diesel 2.2
Gasoline 3.5
0.7 l (0.74 US qt.)
MPI / 3.8 GDI
71 l (18.75 US gal.)
CAUTION
Classification
FMVSS116 DOT-3 or DOT-4
HYPOID GEAR OIL API GL-5, SAE 75W/85
(SK HCT-5 GEAR OIL 75W/85 or
EQUIVALENT)
Refer to Fuel requirements in the introduction
chapter.