Blind-Spot View Monitor System - Hyundai LX2 Owner's Manual

Blind-spot View Monitor
system (if equipped)
BVM (Blind-spot View Monitor) sys-
tem displays the driver-side or pas-
senger-side rear areas in the cluster
when the system is activated.
To turn on BVM system: Under con-
dition BVM system is enabled in the
settings
1. The ignition switch is turned to the
ON position.
2. The turn signal is activated.
To turn off BVM system
1. The ignition switch is turned to the
OFF position.
2. The turn signal is deactivated.
3. Other warning screen pops up and
takes priority over the BVM sys-
tem.
System setting
With the engine ON, the Blind-spot
View Monitor system turns on and
gets ready to be activated when the
OLX2048062L
'User Settings → Driver Assistance
→ Blind-spot safety → Blind-spot
view' is selected on the cluster. The
system stops operation when the
setting is deactivated.
CAUTION
•
Like all assistance systems,
BVM system has limitations.
Over-reliance on the system
may result in a collision.
•
Always look around your vehi-
cle to make sure there are no
objects or obstacles before
moving the vehicle in any
direction to prevent a collision.
•
Objects are closer than they
appear. Failure to visually con-
firm that is safe to change the
lane before doing so may
result in crash and serious
injury or death.
•
Always keep the camera lens
clean. The camera may not
work normally if the lens is
covered with foreign material.
3
3-135