Using The Access Code; Changing The Access Code - Kodak X-Omat 3000 Operator's Manual

Using the Access Code

Only service personnel and one primary person should have use of the access code. The default
access code 4213 is required to perform certain functions.
Simply press the "GO TO SETUP" key on the Walk-Up Menu and enter the access code to perform
the functions listed below:
• to change setup information preset at the factory
• to change to or from the "K/RA" cycle
If the Limited Access Feature is off, an access code is not necessary to perform the functions listed
below:
• to select the Processor cycle (except "K/RA")
• to change the Dryer temperature
• to display the current fixer temperature
• to place the Processor in Sleep Mode
• to display the time and date
The access code can be changed at any time by the user. To change the access code, follow the
procedure below. If you forget the new access code and need to revert back to the original access code,
call your service provider.

Changing the Access Code

[1] From the Walk-Up Menu, press the "GO TO SETUP" key.
READY
[2] Enter the 4-digit access code.
[3] Press the "MORE" key.
[4] Press the "OPTIONS" key.
[5] Press the "MORE" key.
[6] Press the "ACCESS CODE" key.
5B6328 – 30SEP98
DRYER SLEEP
TEMP
1 2
INFO SETUP
REPLEN DAILY
MODE STARTUP
ACCESS USER
CODE ACCESS
SELECT MORE
CYCLE
3 4
CYCLE MORE
OPTIONS
DISPLAY MORE
UNITS
TEMP MORE
LOCK
STD
GO TO
SETUP
CANCEL
REQUEST
DONE/
RETURN
DONE/
RETURN
DONE/
RETURN
DONE/
RETURN
11