Fixed Installation
Four reinforced holes in the rear of the enclosure allow for a screw to pass through to
the mounting brackets.
The enclosure can be mounted to a vertical or horizontal pole.
Slip the screws through the two holes that are side by side in order to mount the
enclosure to a vertical pole. Otherwise slip the screws through the two vertically aligned
holes to attach the enclosure to a horizontal pole.
Loosely assemble the clamp parts around the pole. Note that the screws have nuts that
fit into the clamp parts. The clamp parts are designed to hole the nut so that you do not
need to use a wrench. Hand-tighten the parts until snug.
Mesh Router
66
User Manual