Table of Contents
Advertisement
CHAPTER
10
The Mesh Router has a "Panic" function, where you can manually trigger the relays at the
main TPPLW controller in the network. This must be configured in the Mesh Router in
advance. This function allows you to trigger any individual relay or all relays
simultaneously.
Enabling/Disabling The "Panic Button Function
Note:By default the "Panic Button" function is disabled.
1.
Start the Mesh Router in Diagnostic mode by pressing and holding the [Y/+] and [MODE]
keys simultaneously.
2.
Once startup is completed and the main screen is shown, enter Programming mode by
pressing and holding [MODE] and [N/-] simultaneously.
3.
Provide the 4-digit password and press [Y/+] to enter it.
Note:The default password is "0000."
This screen appears:
4.
Press [N/-] until "Operating Mode" is highlighted.
5.
Press [MODE] to select "Operating Mode."
"Panic Enable" or Panic Disable is highlighted.
Mesh Router
"Panic" Function
47
User Manual
Advertisement
Table of Contents
