Cisco Catalyst IE9300 Hardware Installation Manual page 59

Express Setup
Dual-media downlink ports are sometimes referred to as combination ports or combo ports.
Note
Step 7 Connect the computer to port Gi1/0/23.
The LED continues to blink.
Step 8
After the computer has the IP Address 192.168.1.1, point the browser to http://192.168.1.254.
Step 9 Enter the username and password.
The username is admin, and the password is the system serial number.
The Account Settings window appears.
Step 10 In the Account Settings window, complete the following tasks:
a) Fill out the fields in the Account Settings window as follows:
• Login Name: admin
You can change the login name here, if you like.
• Login User Password: By default, the login user password is the serial number of the switch.
You can change the login user password here if you like.
• Confirm Login User Password: Retype the password that you used earlier.
• Command-Line Password (Optional): This defaults to Sync to Login Password.
You can change the command login password here by using the drop-down menu.
• Device Name: Create an identifier for the device in the network.
• NTP Server (Optional): You may identify an NTP server for the device here.
• Date & Time Mode (Optional): Identify the mode here, through the drop-down.
Trouble
b) After you finish filling in the fields in the Account Settings window, click Basic Settings.
Step 11
In the Basic Settings window, complete the following tasks:
a) Fill out the fields as follows, using English letters and Arabic numbers:
• IP Address: Choose Static or DHCP.
• VLAN ID: Enter a valid VLAN ID.
This is the management VLAN for the switch.
• IP Address: Enter a valid IP Address.
• Subnet Mask: Enter a valid subnet mask.
• Default Gateway: Enter the IP address of the router (not optional if IP is static).
You must enter the router IP address if the IP address is static.
(Optional) On this screen you can also enable or disable Telnet and SSH and configure CIP settings.
If the account settings window does not appear, make sure that any pop-up blockers or proxy settings
on your browser are disabled. Also make sure that any wireless client is disabled on your computer.
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
Run Express Setup
51