Table of Contents
Advertisement
The function is active under the following condi-
tions:
The speed is less than 37 mph (60 km/h) and
R
the indicator has been switched on or the
steering wheel is turned.
The speed is between 37 mph (60 km/h) and
R
50 mph (80 km/h) and the steering wheel is
turned.
The cornering light may still light up for a short
time but is switched o automatically a er a maxi-
mum of three minutes.
%
When reverse gear is engaged, the lighting
switches to the opposite side.
Highbeam Assist
Highbeam Assist
A A dap
daptiv tive Highbeam Assis
e Highbeam Assist function
t function
& W W ARNING
ARNING Risk of accident despite Adap-
tive Highbeam Assist
Adaptive Highbeam Assist does not react to:
Road users without lights, e.g. pedestrians
R
Road users with poor lighting, e.g. cyclists
R
Road users whose lighting is obstructed,
R
e.g. by a barrier
On very rare occasions, Adaptive Highbeam
Assist may fail to recognize other road users
with their own lighting, or may recognize them
too late.
In these, or in similar situations, the automatic
high beam will not be deactivated or will be
activated despite the presence of other road
users.
Always observe the road and tra c con-
#
ditions carefully and switch o the high
beam in good time.
The Adaptive Highbeam Assist automatically
switches between the following settings:
Low beam
R
High beam
R
The system detects that vehicle lights are
approaching in the opposite direction or driving
ahead of the vehicle.
At speeds greater than 19 mph (30 km/h), the
system will switch to the following setting:
If no other road users are detected, high beam
R
will switch on automatically.
At speeds lower than 16 mph (25 km/h) or if there
is su cient street lighting, the system will switch
to the following setting:
High beam will automatically switch o .
R
System limits
Syst
em limits
Adaptive Highbeam Assist cannot take the road,
weather or tra c conditions into consideration.
The detection of obstacles may be restricted if:
visibility is poor, e.g. in fog, heavy rain or snow.
R
the sensors are dirty or covered.
R
Adaptive Highbeam Assist is only an aid. You are
responsible for ensuring correct vehicle lighting in
accordance with the prevailing light, visibility and
tra c conditions.
The system's optical sensor is located behind the
windshield near the overhead control panel.
Switching Highbeam Assis
Switc
hing Highbeam Assist t on/o
on/o
R R eq equir uirements
ements
The light switch is in the à position.
R
T T o switc
o switch on:
h on: switch on high beam using the
#
combination switch.
If high beam is automatically switched on in
darkness, the _ indicator lamp on the mul-
tifunction display will light up.
T T o switc
o switch h o :
o : switch o high beam using the
#
combination switch.
Se Setting t
tting the e
he ext xter erior lighting
ior lighting switc
switch-o
R R eq equir uirements:
ements:
The light switch is in the à position.
R
Multimedia system:
©
Settings
4
5
5
Exterior Lighting Delay
5
Set a switch-o delay time.
#
When the vehicle engine is switched o , the exte-
rior lighting will be activated for the set time.
Light and vision
85 85
h-o dela
delay time
y time
Light
Advertisement
Table of Contents
