Advertisement
Operation
Operating Instructions
Icon
Function
A
Power/Standby
B
Heat
Temperature Down
C
D
Temperature Up
Change Fahrenheit (°F) to
Celsius (°C)
Heat Enable
Heat Disable
E
Colour Themes
F
360° Light
G
Brightness
H
Flame
I
Light Sensor
J
Timer
Control Lock
Control Unlock
12
Description
Press to turn the unit on or put it in Standby mode.
When the unit is turned back on, it will retain the previously used settings (except
timer).
Heat On
Press to turn heat On (indicated by 1 short beep and the icon appearing on the
display). The display will show the current heater temperature setting. Use the Temp
Up/Down icon to change the heater temperature setting.
Heat Off
Press to turn heat Off (indicated by 1 short beep).
Note: After the heater is switched off, the fan will continue on for 60 seconds before
turning off.
Press multiple times to lower the heater temperature in 1°F (1°C) increments. The
display will show the current temperature; the lowest temperature is 41°F (5°C). This
feature is active whenever the heat is enabled.
Press multiple times to raise the heater temperature in 1°F (1°C) increments. The display
will show the current temperature; the highest temperature is 99°F (37°C). This feature
is active whenever the heat is enabled.
Press both Temp+ (
) and Temp- (
•
Hold both Heat (
) and Temp- (
plays on the screen.
•
Hold both Heat (
) and Temp- (
perature is adjusted "---" displays on the screen.
Press multiple times to change the flame base colours from Red-Blue-Off (The first
segment on the display will change from "r" to "b" to blank). This feature is active
only when the fame effect is on.
Press multiple times to change the LEDs on the sides and back of the unit from
Midnight mode to white to yellow to red (the middle segment on the display will
change through 0-3 respectively). This feature is only active when flame is ON.
Press to change the LED lights from High to Low (the last segment on the display
will change from "H" to "L"). The Realog LEDs remain On when the heater is ON and
the flame effect is OFF.
Note: When the light sensor is activated, High and Low flickering brightness settings
are also available (flashing "H" and "L").
Press to light the log set and start the fame effect. Press again to turn this feature off.
Press to activate (ALS ON) the ambient light sensor. Press again to turn the sensor
OFF (ALS OFF).
Note: The light sensor will adjust the brightness of the fireplace based on the
ambient light in the room.
Press multiple times to change the sleeper timer in 0.5 hour increments from 0.5 to 8
hours before turning off. The remaining time on the sleep timer displays.
•
Hold both Temp- (
) and brightness (
the manual controls.
•
Hold both Temp- (
) and Brightness (
the manual controls.
) on the unit.
) on the unit for 2 seconds. Temperature dis-
) on the unit for 2 seconds. When the tem-
) on the unit for 2 seconds to disable
) on the unit for 2 seconds to enable
Advertisement
