Advertisement
SPECIAL
PROGRAMMING
(CONT.)
CLEANING
INSTRUCTIONS
June 2011
3. Press the SET button, and "CAL" shows in the display. Press
and hold TEMP button, and press the UP and DOWN buttons to
match the display with the actual temperature.
4. Press the SET button, and "CPU" shows in the display. Press
and hold TEMP button to view the CPU (control PCB)
temperature.
5. Press the SET button, and "OutPutS" shows in the display. Press
the TEMP button to turn the relays, display and heaters, OFF and
ON.
6. Press the SET button, and "In-" shows in the display. Press and
hold either the UP or DOWN button until "In- SYS" shows in
the display. This programs factory settings back into the
controls.
7. Press the SET button. If "C=y" shows in the display, the time of
day shows in the display during normal operation. If "C=n"
shows in the display, "ON" shows in the display during normal
operation. Press the UP and DOWN buttons to toggle from one
to the other.
1. Turn the unit to the OFF position.
2. Disconnect electrical supply to the unit.
To avoid burns, allow the unit to cool before cleaning.
3. Open doors and wipe down racks.
4. Clean doors with a non-abrasive, soft cloth and mild soap.
Do not use ammonia.
Do not use steel wool, other abrasive cleaners or
cleaners/sanitizers containing chlorine, bromine, iodine
or ammonia chemicals, as these will deteriorate the
stainless steel material and shorten the life of the unit.
Do not spray the unit with water, such as with a garden
hose. Failure to follow this caution could cause component
failure.
5. Clean the interior and exterior of the unit with a soft cloth,
soap, and water.
6
Model BW-100/BW-4/BW-4/3/BW-6/BW-8
Advertisement
