Special Mode; Special Mode Setting Button - Marantz SR5006 Service Manual

SPECIAL MODE

Special mode setting button

b No.1 - 4, 6-10 : Press the ON/STANDBY button to turn on the power while pressing both the button A and the button B at the same
time.
b No.5 : The AC power cord on while pressing both the button A and the button B at the same time.
b No.11 - 14 : Turn on the power, then press and hold down the button A and button B for over 3 seconds.
No. Mode
Version display
1
(μcom/DSP Error Display)
2 Displaying the protection history mode
User Initialization mode
3
(Installer Setup settings are not initialized.)
Factory Initialization mode
4 (Installer Setup settings are also
initialized.)
Mode for switching tuner frequency step
5
(U/N model only)
Mode for preventing remote control
6
acceptance
7 Panel lock mode
Panel lock mode
8
(Master volume is not locked.)
9 Cancellation of panel lock mode
10 Installer Setup mode
11 Diagnostic mode
12 Memory Backup
13 Memory Recovery
14 Memory Backup Clear
s
Button A
ZONE
SELECT
INTERNET
RADIO
ZONE
SELECT
M-DAX
PURE
DIRECT
PURE
DIRECT
PURE
DIRECT
PURE
DIRECT
PURE
DIRECT
ZONE
SELECT
ZONE
SELECT
M-DAX
M-DAX
M-DAX
M-DAX
ON/STANDBY DISPLAY
PURE
DIRECT
Button B
Firmware versions such as Main or DSP are displayed in the FL Display.
STATUS
Errors are displayed when they occur. (Refer to 19 page)
ONE TOUCH The protection history is displayed.
PLAY (Refer to 21 page)
Backup data initialization is carried out.
DISPLAY
(Installer Setup settings are not initialized.)
Backup data initialization is carried out.
DISPLAY
(Installer Setup settings are also initialized.)
STATUS Change tuner frequency step to FM:200kHz/AM:10kHzSTEP
Operations using the remote control are rejected.
ONE TOUCH
(Mode cancellation: Turn off the power and execute the same button
PLAY
operations as when performing setup.)
Operations using the main unit panel buttons or the master volume knob
DISPLAY
are rejected.
STATUS Operations using the main unit panel buttons are rejected.
ZONE
Panel lock mode is cancelled.
SELECT
Access the Remote Maintenance mode via the internet.
M-DAX Installer Setup is displayed on GUI/Option Menu.
b Refer to AVR_RemoteMaintenance_.pdf of SDI.
This mode is used for confirming the Video and Audio (signal) paths.
PURE
(Troubleshooting)
DIRECT
The signal paths of the set can be easily confirmed after repair.
STATUS Backup of DUAL BACKUP MEMORY is performed. (Refer to 23 page)
DISPLAY Recovery of DUAL BACKUP MEMORY is performed. (Refer to 23 page)
ZONE
Backup of DUAL BACKUP MEMORY is cleared. (Refer to 23 page)
SELECT
INTERNET
RADIO
STATUS
ONE TOUCH
PLAY
ZONE
SELECT
18
Contents