Special Mode; Special.mode.setting.button - Marantz SR6006/U1B Service Manual

SPECIAL MODE

Special mode setting button
b No.1 - 4,6 - 9 : Press the ON/STANDBY button to turn on the power while pressing both the button A and the button B at the same
time.
b No.5 : The AC power cord on while pressing both the button A and the button B at the same time.
b No.10 - 13 : Press and hold both buttons A and B for over 3 second with the power turned on.
No. Mode
Version display
1
(μcom/DSP Error Display)
2 Displaying the protection history mode
User Initialization mode
3
(Installer Setup settings are not initialized.)
Factory Initialization mode
4 (Installer Setup settings are also
initialized.)
Mode for switching tuner frequency step
5
(U/N model only)
Mode for preventing remote control
6
acceptance
7 Panel lock mode
Panel lock mode
8
(Master volume is not locked.)
9 Cancellation of panel lock mode
10 Diagnostic mode
11 Memory Backup
12 Memory Recovery
13 Memory Backup Clear
14 Installer Setup mode
NOTE:
If "SUB LOG display mode"(
RS-232C communications are not possible.
Turn on the power, then press and hold down the "PURE DIRECT" and "STATUS" buttons for over 3 seconds to turn off
"SUB LOG display mode"(
Button A
ZONE
SELECT
INTERNET
RADIO
ZONE
SELECT
M-DAX
PURE
DIRECT
PURE
DIRECT
PURE
DIRECT
PURE
DIRECT
PURE
DIRECT
ZONE
SELECT
M-DAX
M-DAX
M-DAX
ZONE
SELECT
) is displayed on the fluorescent display, the set is in the special developer's mode and the
b
) on the display. RS-232C communications are now enabled.
b
M-DAX
ON/STANDBY DISPLAY
PURE
DIRECT
Button B
Firmware versions such as Main or DSP are displayed in the FL
STATUS
Display. Errors are displayed when they occur. (Refer to 20 page)
ONE TOUCH The protection history is displayed.
PLAY (Refer to 22 page)
Backup data initialization is carried out.
DISPLAY
(Installer Setup settings are not initialized.)
Backup data initialization is carried out.
DISPLAY
(Installer Setup settings are also initialized.)
STATUS Change tuner frequency step to FM:200kHz/AM:10kHzSTEP
Operations using the remote control are rejected.
ONE TOUCH
(Mode cancellation: Turn off the power and execute the same
PLAY
button operations as when performing setup.)
Operations using the main unit panel buttons or the master volume
DISPLAY
knob are rejected.
STATUS
Operations using the main unit panel buttons are rejected.
ZONE
Panel lock mode is cancelled.
SELECT
This mode is used for confirming the Video and Audio (signal)
PURE
paths. (Troubleshooting)
DIRECT
The signal paths of the set can be easily confirmed after repair.
Backup of DUAL BACKUP MEMORY is performed. (Refer to 24
STATUS
page)
Recovery of DUAL BACKUP MEMORY is performed. (Refer to 24
DISPLAY
page)
ZONE
Backup of DUAL BACKUP MEMORY is cleared. (Refer to 24 page)
SELECT
Access the Remote Maintenance mode via the internet.Installer
M-DAX Setup is displayed on GUI/Option Menu.
b Refer to AVR_RemoteMaintenance_.pdf of SDI.
INTERNET
STATUS RADIO
ONE TOUCH
PLAY
ZONE
SELECT
17
Contents
(b)